Robomow Help Center Type your question Or Choose a category to find the help you need

The Robot found on the Base Station with Failure 67

Q1 . Does it happen when sending the robot manually to the Sub Zone?

If Yes – Check the installation was done properly according the manual.
If No – Proceed to Q2

 

Q2 . What is the length of the Perimeter wire? Is it more than 500m?

If Yes – Add the adaptor SPP6117A (from 500m up to 800m). If the problem still
exists, proceed to Q3
If No – Proceed to Q3

 

Q3 . Change the Wire Gain settings from 75 to 80 by going to the Service (Requires receiving a temporary code from Hotline agent) --> Operation --> Wire Gain Switch. Does it solve the problem?

If Yes – Everything is ok, continue to work with Robomow.
If No - The robot needs to be taken for repair to an Authorized Service Station.